If you keep a light coat of oil on it, that will keep it from rusting. Just
clean it off thoroughly before you install it.
I always have flywheels magnafluxed to check for cracks. It's not expensive
and it's cheap insurance.
The brake bleeders are different. I know the attachment won't come through
on the list, but Tim will see it. The front bleeder is on the left.
Description for everyone else: the front bleed screw has a flat end that
pushes up against a steel ball (like a bb). The rear bleed screw has a
pointed end and no bb.
Gordon Glasgow
-----Original Message-----
From: datsun-roadsters-bounces@autox.team.net
[mailto:datsun-roadsters-bounces@autox.team.net] On Behalf Of Tim
Sent: Monday, February 14, 2011 4:34 AM
To: datsun-roadsters: autox.team.net
Subject: [Roadsters] flywheel resurface
I am going to have a spare flywheel resurfaced in anticipation of doing the
clutch on my 2000 this spring.
Do I have to worry about it rusting or can I have it done now? Or should I
wait until right before we pull the motor?
Anything else I need to worry about or have checked on the fly wheel while
it is at the machinist?
Still looking for an answer on the bleeders.....
Thanks
Tim
Dairyland Datsuns
________________________________________
Datsun-roadsters@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $16.00
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/datsun-roadsters/gsglasgow@comcast.net
[demime 1.01d removed an attachment of type image/jpeg which had a name of
Brake_Bleeder_comparison.jpg]
________________________________________
Datsun-roadsters@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $16.00
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|