Perry,
I presume you did not pull the engine to pull the head. You do not say
whether you replaced the chains and sprockets. If you did, I presume you
have lined up the timing marks on the sprockets as shown in the manual.
1. Put the head on with or without the manifolds, as you prefer. I have
always pulled the manifolds before removing the head when doing head work
with the engine in the car, but do whichever works well for you. It will be
easier to get at the inner studs/nuts on Number 4 exhaust port with the head
off the car.
2. No need to pull the engine.
3. Follow the alignment diagram on Page 23 of the shop manual, and you
won't go wrong. (Again, you didn't say whether you replaced the chains and
sprockets. If you did not, then I presume you preserved the position of the
camshaft sprocket with the upper chain. If you lose that relationship, I
know no way to correct things short of removing the oil pan, water pump and
timing cover to make sure all alignment marks are in the correct position.)
Sorry I could not be more help with Point 3. Provide more detail on what
has been done to the engine, and how the timing component relationships have
bee maintained or re-established, and perhaps I can say something further.
Gary
----- Original Message -----
From: "Perry Smith" <tpsmithstl@yahoo.com>
To: <datsun-roadsters@autox.team.net>
Sent: Sunday, March 14, 2010 4:42 PM
Subject: [Roadsters] Head Installation
> Hi all,
>
> It's been a while, but I'm ready to put the head back on my '68 2000
> after the nasty "Evil-L" episode of a couple years ago. I bent roug
> valves on
> that one! The head is redone and the valve train was re-installed at the
> machine shop. When I pulled the head, I took the intak, exhaust manifolds
> and
> head off together. Questions raised are:
>
> 1. Is it easier to just put the head
> back on and then the intake and exhaust manifolds separately, or try to
> put
> them together off the car first (as I did when removing them) to put the
> head
> back on?
>
> 2. Should I just pull the whole engine, assemble everyting and then
> put it back in the car?
>
> I have the manual, so my plan is to set the timing
> manually/ My only concern is getting the timing 180-degrees off so I
> don't
> end-up back when re I started. Any idea bout whether the manual has a
> sure-fire way of making sure that doens't happen. (Sorry, I'm really
> tired or
> I'd look it up myself!)
>
> Thanks,
> Perry Smith
> '68 2K, still U20
> ________________________________________
> Datsun-roadsters@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $16.00
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/datsun-roadsters/aultgc@att.net
________________________________________
Datsun-roadsters@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $16.00
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|