datsun-roadsters
[Top] [All Lists]

Re: [Roadsters] brake bleeding woes

To: Datsun Roadster List <datsun-roadsters@autox.team.net>
Subject: Re: [Roadsters] brake bleeding woes
From: Pete Peters <ppeters914@comcast.net>
Date: Thu, 4 Mar 2010 22:22:15 +0000 (UTC)
Gee, who knew you'd need a rotisserie to bleed brakes. <g> 

Pete 

----- Original Message ----- 
From: "Gary Boone" <gboone70@yahoo.com> 
To: datsun-roadsters@autox.team.net 
Sent: Thursday, March 4, 2010 2:17:28 PM GMT -08:00 US/Canada Pacific 
Subject: Re: [Roadsters] brake bleeding woes 

Andy's solution makes perfect sense. I've always wondered if we have the same 
problem with the rear wheel cylinders since the bleeders are on the bottom of 
the cylinders. What were they thinking when they designed that? It's a bit 
difficult to turn the car upside down to bleed the rear brakes. 



----- Original Message ---- 
From: Andy Cost <andycost@embarqmail.com> 
To: datsun-roadsters@autox.team.net 
Sent: Thu, March 4, 2010 5:14:49 AM 
Subject: Re: [Roadsters] brake bleeding woes 

I've had problems with air bubbles in the master cylinder. The master 
cylinder slopes up away from the driver. A bubble can get in the very end. 
All the bleeding in the world wouldn't get it out. My solution was to take 
the front wheels off and set the front end almost on the ground. I then 
jacked the rear of the car several feet up. I think I either backed the 
rear wheels onto the trailer or I used my engine crane to pick the rear up. 
Anyway, I jacked it up in the rear until a torpedo level on the master 
cylinder showed it was sloped slightly the other way. A few pumps with the 
bench bleeder screws open and a large bubble made its way through the tube. 
Then the brake pedal was very stiff. 

Andy 

-----Original Message----- 
From: datsun-roadsters-bounces@autox.team.net 
[mailto:datsun-roadsters-bounces@autox.team.net] On Behalf Of steven boortz 
Sent: Thursday, March 04, 2010 12:11 AM 
To: datsun-roadsters@autox.team.net 
Subject: [Roadsters] brake bleeding woes 

Hi everyone 

I just don't get it. How can I have clear bubble-less fluid out of all 8 
bleeder screws, and still no pedal? Bad (new) master cylinder? 

I have volvo calipers in front. Last time out brakes were fine. Took them 
apart to add cooling ducts. Re-assembled and tried to bleed system, but m/c 
leaked out the back. Replaced with NOS aftermarket m/c. 

Thanks for your help 
S 
675MIZU 
________ 
________________________________________ 
Datsun-roadsters@autox.team.net 
Donate: http://www.team.net/donate.html 
Suggested annual donation $16.00 
Archive: http://www.team.net/archive 
Forums: http://www.team.net/forums 
Unsubscribe: 
http://autox.team.net/mailman/options/datsun-roadsters/ppeters914@comcast.net 
________________________________________
Datsun-roadsters@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $16.00
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>