I use white lithium grease. I believe it is generically called
Luberplate. It comes in a very large toothpase looking tube
Peace,
Pat
Thusly spake ljordan704@netscape.net, On 9/18/2009 9:33 AM:
> Thanks all for the really good info on cleaning the engine after machining.
>So it appears that none of the soaps? would harm the bores? I wondered about
>anything too acidic, "etching" the surfaces.
> Oiling after cleaning I assume is regular oil.
> Then once assembly begins the "assembly lube" is used. What is recommended
>for that?
> thanks,
> Linda
> ________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as pat@hornesystemstx.com
>
> Datsun-roadsters mailing list
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/datsun-roadsters
>
>
>
--
Pat Horne, Owner, Horne Systems
(512) 797-7501 Voice 5026 FM 2001
Pat@HorneSystemsTx.com Lockhart, TX 78644-4443
www.hornesystemstx.com
-- We support Habitat for Humanity - a hand UP, not a hand OUT --
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|