datsun-roadsters
[Top] [All Lists]

Re: [Roadsters] Sun-visor/rear-view mirror screws

To: <Keith0alan@aol.com>, <vociferouschicanery@yahoo.com>,
Subject: Re: [Roadsters] Sun-visor/rear-view mirror screws
From: "Larry Dziuba" <roadster68@shaw.ca>
Date: Wed, 30 Jul 2008 08:20:31 -0600
My sun visor ends do not sit square to the housing so tightening the screws 
does nothing to keep them up and out of my way.  The screws see to be very 
short.  Any ideas?  Larry.
----- Original Message ----- 
From: <Keith0alan@aol.com>
To: <vociferouschicanery@yahoo.com>; <9laser3@bright.net>; 
<gtpjimgammon@yahoo.com>; <datsun-roadsters@autox.team.net>
Sent: Tuesday, July 29, 2008 3:55 PM
Subject: Re: [Roadsters] Sun-visor/rear-view mirror screws


> The problem with those is that the stud is steel. It rusts and fills the
> space between the stud and housing with rust. Since rust is bigger than 
> the
> parent metal it is packed in really tight. I assume the top piece that the 
> cap
> screws onto is removed. Take a drill with a 1/16" bit and drill down 
> between
> the stud and the aluminum housing. Work your way around each stud drilling 
> out
> the rust. This will give the penetrant somewhere to go. After drilling out 
> the
> rust fill the area around the stud with your favorite rust buster. Let it
> sit  for a few days topping it off if necessary. You can also tap the 
> studs
> sideways  a bit with a plastic hammer to break up the rust. Then heat the 
> housing
> till the  penetrant just starts to bubble. (warning: it may flame on you) 
> Then
> tap  the sides of the housing with a plastic hammer. This should break it
> loose. Once  it is apart I usually replace the studs with ones made from
> stainless steel. My  next choice would be to clean and paint them then 
> squirt grease
> between the stud  and housing when put back together.
>
> keith
>
>
> In a message dated 7/29/2008 1:40:12 P.M. Pacific Daylight Time,
> vociferouschicanery@yahoo.com writes:
>
> hi  everyone
> i've been soaking (with liberal applications of PB Blaster) the  studs
> holding on the thermostat housing to my aluminum R16 head for over a 
> month.  and it
> still won't budge.  i've tried some manual persuasion  of the hammering
> variety, to no avail.  should i add a little  heat?
> s
> 675MIZU
>
>
>
>
>
>
> **************Get fantasy football with free live scoring. Sign up for
> FanHouse Fantasy Football today.
> (http://www.fanhouse.com/fantasyaffair?ncid=aolspr00050000000020)
> ________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> You are subscribed as roadster68@shaw.ca
>
> Datsun-roadsters mailing list
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net  http://www.team.net/donate.html


Datsun-roadsters mailing list

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/datsun-roadsters

<Prev in Thread] Current Thread [Next in Thread>