Sun visors are easy. Wait until you try the upper a-arm spindle bushings!
I soaked them for almost two weeks and still bent the breaker bar!
Paul
JB BLASTER user
Ohio
-----Original Message-----
I believe Liquid Wrench works best, but it does take days, and it is best to
wire brush any dirt/rust off the surface first. I have also been known to
tap the metal parts with a hammer to help.
JimG
--- On Tue, 7/29/08, Tim <tputland@charter.net> wrote:
> I have let bolts soak for several days as well. With some of
> the fender bolts you most likley would not be able to get
> them out even after a week of soaking but the visor mounts
> should loosen up with some patient soaking.
>
> Tim
> =============
> Dave,
> I have an original 64 with every screw and bolt on the car
> rusted in. Before I
> attempt any removal, I soak the screw/bolt with Marvel
> Mystery oil and let it
> set for 2-3 days....yeah, 2-3 DAYS! It takes a lot of
> planning and patience,
> but I've stopped busting bolt heads off or stripping
> screws. A persuasive tap
> with a hammer after soaking helps free them up.
> Good luck!
> Patti
> ---
>
> On a similar topic to the bolt heads... any hope of getting
> my
> sun-visor and rear-view assembly off? I've tried WD-40
> so far without
> any success, but I'm reluctant to really twist hard in
> fear of
> deforming the phillips head and then never getting it off.
> Suggestions?
>
> Dave Riedel
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|