My WAG's:
What gage wire are you using for the + to the battery, and firewall? I seem
to recall that the thinner the wire the more resistance (actuall less
conductivity) it has and therefore potential overload on a fuse.
Also, have you checked that the ground at the firewall is making good
contact?
Lastly, have you checked that the prong that holds the lighter when it's
depressed isn't overly tight? That prong is designed to expand with the
heat from the lighter element, but sometimes they can be overly tight
causing the lighter to overheat before it will expand that prong enough to
release the lighter. It should be tight enough to hold the lighter against
it's spring, but loose enough that once it heats up it allows it to pop out
of the prong (not the holder).
HTH
E
> Hi Everyone,
>
> I know this is trivial, but here goes. I added an aftermarket cigarette
> lighter (don't have a center console). I have it wired completely separate
> from everything else in the car. (-) is to the firewall and (+) is to the
> battery, thru a 30 amp fuse. Here's the problem. That 30 amp fuse blows
> every other time I use the lighter. Would it be OK to remove the fuse from
> the circuit? The socket is ONLY used for the cigarette lighter. I don't
> use
> any other components in it (charger, light, or stuff like that). Should I
> use a fusible link wire so it will blow slower and give the lighter time
> to
> get hot?
>
> Matt
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|