-----Original Message-----
From: datsun-roadsters-bounces+tom=datsun2000.com@autox.team.net
[mailto:datsun-roadsters-bounces+tom=datsun2000.com@autox.team.net]On
Behalf Of Matthew A. Smith
Sent: Friday, January 11, 2008 5:55 PM
To: 'Larry Dziuba'; datsun-roadsters@autox.team.net
Subject: Re: [Roadsters] 68-70 soft top frame question - dial up users,
please don't open
>> I also carry a 1" C-clamp and snug down my center latch before I get on
the
interstate. It gets installed in a U position, points up, since scratches on
the latch are MUCH easier to live with than no top!
I played around with all three of the windshield clamps when the top shop
forgot to put the spacer back in the center clamp. After making a new
center spacer (Shasta was too close to wait for them to open) and playing
with the gap by adding and removing washers I finally found a spacing that
allowed me to clamp the top frame down and it did not pop off. The problem
then was the side clamps. Figuring what was good for the gander is good for
the goose I made thin spacers for each side clamp made things much more
reliable. I have hit some solid bumps without popping the clamps off of the
windshield. They are now solid, easy to clamp and release, and do not
rattle at all.
To clamp the top I start with the outside clamps and the center clamp lines
up without any problem.
Tom
69 2000 - Mr. Hyde
Portland
http://www.datsun2000.com
http://www.nowroc.org
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|