IIRC, someone posted here or on 311s.org that the nuts are welded onto the
firewall and the studs/bolts are removable.
Pete
-----Original Message-----
From: owner-datsun-roadsters@Autox.Team.Net
[mailto:owner-datsun-roadsters@Autox.Team.Net] On Behalf Of Fergus OFarrell
Sent: Monday, July 23, 2007 4:13 PM
To: datsun-roadsters@autox.team.net; ME-Work
Subject: removal technique, brake brace stud, Roadster Bar-B-Q noticeables
Sorry if I have asked this before, suffering from CRS again.
I bought a brake brace a long time back, and since I am in the process of
replacing my clutch master cyl, I should probably tackle this as well.
So my question:
Is the lower brake master cyl stud tack welded to the body, or is threaded
in? Is the suggested way to remove the brake master, then give the stud a
short-sharp-shot, or do I wire brush all the crud off the back and try to
screw it back out? (I think this requires removing the entire brake pedal
assy to get a straight shot at the bolt)
thanks for any help,
Fergus O, 69 2000, HB, CA
|