Re: Which rear-end to use

datsun-roadsters

Re: Which rear-end to use

To:	<datsun-roadsters@autox.team.net>
Subject:	Re: Which rear-end to use
From:	"Andy Cost" <andycost@earthlink.net>
Date:	Mon, 12 Dec 2005 16:23:30 -0600

I'm using an 84 RX7 rear axle.  They are stronger than the roadster one.  If
you get the 85 GSL SE model it is already 4x4.5 bolt pattern.  The width of
the RX7 axle is 57 inches.  The Roadster is 48 inches.  The RX7 Axle needs
to be narrowed.  Moser can do all the narrowing and they aren't too
expensive.

[More with this subject...]

<Prev in Thread]	Current Thread	[Next in Thread>
Which rear-end to use, BARTERDUDE RE: Which rear-end to use, Eric Hankinson Which rear-end to use, Eric Hankinson Re: Which rear-end to use, Andy Cost <=

Previous by Date:	U20 - Valve Cover Spacer, Nathaniel Leeds
Next by Date:	RE: Weather proofing, Gordon Glasgow
Previous by Thread:	Which rear-end to use, Eric Hankinson
Next by Thread:	Weather proofing, Nathaniel Leeds
Indexes:	[Date] [Thread] [Top] [All Lists]