Eric,
Is the bow warping towards the windscreen in the middle, or away from
it? It almost seems that you wold need to weld it up while clamped to
the windscreen (mmm...burnin' rubber) or fashion a jig to avoid
warpage. If you felt like cutting it open and doing it again, you
could fasten it to a piece 0f MDF cut to the bow profile with long
shetmetal screws into the top retaining strip screw holes (or purpose
drilled holes). Or you could just depend on the gasket to make the
seal. It's not like it's going to be leak-free in any case ;-)
-Marc T.
On Jul 18, 2004, at 6:02 PM, Eric Frisbee wrote:
> What I meant to write was that it's not just wavy in the general
> areas, but
> when put on the car, seems that there is a slight warpage about in the
> middle? I guess the gasket will take care of that, but wanted to be
> more
> precise closure for the top than before. I'm still busy playing and
> hopefully will find that perfection I am seeking! Funny thing is
> it's for
> a car I hope to sell too! haha!
>
> Eric
>
================================================
The perfect is the enemy of the good.
|