Paul,
I must have a loose connerctor. I have no idea what you just said. Any
particular connector in mind?
Guy
Tempe, AZ
PS A glorious fall day. Only a tad above 100 degrees.
.
Paul Bauman wrote:
>If this connector gets loose it will also cause intermittant firing, too.
>
>Paul Bauman
>
>
>-----Original Message-----
>From: owner-datsun-roadsters@autox.team.net
>[mailto:owner-datsun-roadsters@autox.team.net]On Behalf Of Adam Bradley
>Sent: Sunday, September 14, 2003 12:44 PM
>To: datsun-roadsters@autox.team.net
>Subject: Figured out why it wouldn't run
>
>
>A few months back I had an electrical problem, no spark. It went away but
>then came back and I let the car sit for a while and ignored it (big
>mistake, I know). Yesterday I took off the spade on the side of the
>distributor that the hot wire and the condenser attaches to (outside) and
>the wire for the points attaches to (inside). It was icky, corroded,
>covered with gunk. A simple cleaning of that and the car runs great
>again. Just goes to show you it's often the simple things and the last
>comment about cleaning connectors sure is true!
>
>Adam Bradley
>'70 Datsun 1600 Roadster SPL311-28181
>'66 Datsun PL411 sedan PL411-022447
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|