Standard head thickness is 115mm or 4.528"
Stan
==========
At 03:40 PM 6/7/03 EDT, JOver4X4@aol.com wrote:
>List,
>
>I recently purchased a 68 2000. I have the carbs/manifold removed for a
>rebuild and header install. I am diagnosing a noisy timing chain. The
upper
>tensioner is showing only very slight wear. The cam towers are shimmed
.040". I
>know the head on my car has been milled at least .070" by comparison to
the 2
>spare heads I have in the garage. I think I have found the problem and can
>use the spare head(s), but would like to know if they have been milled as
well.
>Does anyone know the original cylinder head thickness of the 2L head?? I
saw
>this spec on some web page a week ago but cannot relocate it.
>
>Thanks in advance.
>
>John Over
>Aurora, CO
>68 2000
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|