4.528-4.530"
http://www.gordon-glasgow.org/U20specs.asp
Gordon Glasgow
Renton, WA
www.gordon-glasgow.org
> -----Original Message-----
> From: owner-datsun-roadsters@autox.team.net
> [mailto:owner-datsun-roadsters@autox.team.net]On Behalf Of
> JOver4X4@aol.com
> Sent: Saturday, June 07, 2003 12:40 PM
> To: datsun-roadsters@autox.team.net
> Subject: 2000 cylinder head thickness
>
>
> List,
>
> I recently purchased a 68 2000. I have the carbs/manifold removed for a
> rebuild and header install. I am diagnosing a noisy timing
> chain. The upper
> tensioner is showing only very slight wear. The cam towers are
> shimmed .040". I
> know the head on my car has been milled at least .070" by
> comparison to the 2
> spare heads I have in the garage. I think I have found the
> problem and can
> use the spare head(s), but would like to know if they have been
> milled as well.
> Does anyone know the original cylinder head thickness of the 2L
> head?? I saw
> this spec on some web page a week ago but cannot relocate it.
>
> Thanks in advance.
>
> John Over
> Aurora, CO
> 68 2000
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|