What you're missing is a mess :)
I polished aluminum parts and it was messy, very, very messy. On cast parts
you'll need to grind/sand them smooth and then use large buffing wheels on
your bench grinder using stainless compound and then rouge if you so desire
but IMHO a waste as the stainless makes the aluminum shine well and it cuts
fast.
Messy, very messy.
If I had to do it again I'd send them out to be done and save yourself a
mess and a lot of time and equipment that you'll need to do it correctly.
Mike
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|