Mine uses one cable clamp on the rear carb body, but I run the bare cable
through the back bellcrank fitting to the front fitting, adjusting to balance an
even choke opening.
- Bob Mann. '69 2000 Solex
Allen wrote:
>
> To List,
>
> I'm nearly finished with my engine install. I have a question about Solex
> choke cables. I have some new SU choke cables, but they are way too long.
> Can I cut these to fit my car? How do I cut them? Also, did the Solex set up
> have one cable or two? I can only find one "fitting/holder that is used to
> clamp the cable in place to keep it from moving around. It's on my back carb
> but none on the front carb. I'm not talking about where it attaches to the
> "choke" on the carb, but rather a fitting that the cable housing clamps on.
> Was there only supposed to be one cable that worked for both carbs? If so,
> does anyone have a good choke cable or have advice? Thanks!!
>
> Allen
> 1970 2000 13774
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|