Had some starting problems for a while. Turned out the spring in the 30A
inline fuseholder I installed near the ammeter had weakened and the fuse was
not making good contact. Removed the holder & everything works great. Time for
a blade type fuse/holder.
My leaky rad got recored (3 row) and re-installed & the temp seems to run a
little high. I missed some of the suggestions previously posted on "bleeding"
the cooling system. If someone could send some suggestions?
Hardtop. My current softtop has about reached the end of it's useful life. I
cannot afford to replace it at this time, BUT I have a good hardtop that just
needs new weatherstripping. I am short on time (school) so am looking at
having it done somewhere.
Any suggestions as to who would be able do do a decent job on it & how much it
should cost? ALL of the weatherstrip needs to be replaced.
( I'm getting tired of scraping frost off the INSIDE of the windshield!) !!
Any sugestions for a higher ouput heater fan?
OT - Anyone into electronics have time to answer a few power supply
questions?
Thanks
Daryl
'66 1600
Vancouver,BC
/// datsun-roadsters@autox.team.net mailing list
|