You are fighting the effects of corrosion caused by Galvanic effect combined
with deteriorated shaft seals. I have had to cut them apart on occasion due to
the aluminum shoulder inside being too soft to hold well as I forced the nut
off after trying several methods to remove the outside nut.
Good luck!!!
Ron
TIM WALTZ wrote:
> I'm having a tough time getting the wiper assembly off of the body of the
> car. The assembly seems to be frozen by some sort of corrosion, although I
> cannot see any rust. (I believe this is why the wipers never worked on my
> car, although the motor was getting hot from trying)
>
> I've tried holding the base from the interior with channel-locks while
> trying to loosen the nut with a wrench or socket. No luck.
>
> Any suggestions on getting these off?
>
> Tim Waltz
> 67.5 1600's
>
> _________________________________________________________________
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
|