datsun-roadsters
[Top] [All Lists]

Re: Waterpump - again

To: Adam Bradley <ambradley@yahoo.com>,
Subject: Re: Waterpump - again
From: Mike Harper <roadsterdude1600@yahoo.com>
Date: Fri, 27 Jul 2001 18:49:10 -0700 (PDT)
I do not know whether this is a Nissan part # or not,
but my invoice from Budget Forklift (Kansas City) is
21010-78226 for the water pump that perfectly fits my
early R-16 (R-01753)    
$50, BTW...www.budgetforklift.com

Mike Harper  
'66 1600
Charleston SC

--- Adam Bradley <ambradley@yahoo.com> wrote:
> I didn't get the part number, but based on Sidney's
> recommendation may
> pick it up and have another machine shop swap the
> pulley "thingies". 
> If I do, I'll give you the part number.
> 
> Adam
> 
> --- "Patrick J. Horne" <horne@cs.utexas.edu> wrote:
> > What is the part number for the H20 water pump?
> > 
> > Peace,
> > Pat
> > 
> > - Support Habitat for Humanity, A "hand up", not a
> "hand out" -
> > 
> > Pat Horne, Network Manager, Shop Supervisor,
> Future planner
> > CS Dept, University of Texas, Austin, Tx. 78712
> USA
> > voice (512)471-9730, fax (512)471-8885,
> horne@cs.utexas.edu
> > 
> > On Fri, 27 Jul 2001, Adam Bradley wrote:
> > 
> > > Well, after my recent repairs/alternator
> relocation my water pump
> > > started leaking, and I thought it was from the
> gaskets in front of
> > and
> > > behind the water pump spacer, so I pulled it all
> apart, cleaned it,
> > and
> > > put it back together.  Now it is leaking worse
> than before and I
> > think
> > > it's coming from the shaft, not the gaskets. 
> There is also a mild
> > > clanking noise coming from the water pump.  Time
> for another $110
> > water
> > > pump...
> > >
> > > Anyway, I stopped by my local Nissan forklift
> dealer and they do
> > have
> > > the H20 water pump (Nissan brand) for $66, with
> all the correct
> > holes
> > > in the backing plate, and the casting is an
> exact match (although
> > there
> > > is some different writing/etc. in the casting),
> BUT the pulley
> > mounts
> > > differently, probably more like the early R16. 
> They offered to
> > swap
> > > the pressed-on piece (what do you call that?)
> but at $58/hour, it
> > would
> > > cost as much as or more than an R16 water pump. 
> Oh well.
> > >
> > > =====
> > > Adam
> > > '70 1600 SPL311-28181
> > > http://www.picturetrail.com/abend
> > > Make international calls for as low as
> $.04/minute with Yahoo!
> > Messenger
> > > http://phonecard.yahoo.com/
> 
> 
> =====
> Adam
> '70 1600 SPL311-28181
> http://www.picturetrail.com/abend
> Make international calls for as low as $.04/minute
> with Yahoo! Messenger
> http://phonecard.yahoo.com/
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/

<Prev in Thread] Current Thread [Next in Thread>