datsun-roadsters
[Top] [All Lists]

Re: slipped crank pulley ?

To: sochoux@yahoo.com, datsun-roadsters@autox.team.net
Subject: Re: slipped crank pulley ?
From: "sidney raper" <spl310@hotmail.com>
Date: Tue, 17 Jul 2001 17:05:44 -0400
Stephan,

Did you disconnect the vacuum advance?

Sid


>From: Stephan Sochoux <sochoux@yahoo.com>
>Reply-To: Stephan Sochoux <sochoux@yahoo.com>
>To: datsun-roadsters@autox.team.net
>Subject: slipped crank pulley ?
>Date: Tue, 17 Jul 2001 13:42:11 -0700 (PDT)
>
>Hello all,
>
>Went to check my timing and could not find a timing
>mark.... clipped the timing light pick-up on #2 and
>got 46 degrees...
>I pulled the valve cover, put #1 at end of compression
>stroke, checked the distributor and it was pointing at
>#1. My conclusion: the crank pulley has slipped.
>A few questions now:
>- Does the crank pulley have 2 pieces to it?  I don't
>remember when assembling the motor.
>- If it doesn't, then the key broke ?
>- Can i drive like this until i change it?
>
>Thx,
>
>Stephan
>'69 2000
>Get personalized email addresses from Yahoo! Mail
>http://personal.mail.yahoo.com/

_________________________________________________________________

<Prev in Thread] Current Thread [Next in Thread>