FWIW: I guess the really unique thing about this piece is that it has "NO
holes".
It is heavier gauge and much stronger, since it is made from two pieces.
It can be welded in and eliminate the screw mounts and does not have holes
for fog lamps. It is what i wanted to smooth out the front end appearance.
If you are going stock, not what you want.
This was made from a 67.5 apron, but works well on the 68 and 70 that I
have.
Thanks, BZ
----Original Message Follows----
From: "Ben Zech" <motormite@hotmail.com>
Reply-To: "Ben Zech" <motormite@hotmail.com>
To: datsun-roadsters@autox.team.net
Subject: Front Apron Assy - Reproduction
Date: Sat, 09 Jun 2001 11:42:31 -0400
List, I have found a shop to make the front apron assy.
Take a look at the pictures at the site listed below.
Cost $265.00 + s/h.
If interested, let me know.
http://albums.photopoint.com/j/AlbumIndex?u=185114&a=12118916&f=0
BZ/RZ/NC/SPL/SRL/"SEROC"
motormite@hotmail.com
_________________________________________________________________
_________________________________________________________________
|