Bosch LH 2.4 ???
Thomas
James Uhl wrote:
> Hey guys, this and other posts have me wondering..... would there be any
> interest in a reliable (Bosch) Electronic Fuel Injection kit for the
> Roadsters? I'm pretty sure I have the means to produce one if I put my mind
> to it. I'm planning on making one for myself when the time comes.
>
> I would imagine the cost to be under $700 with used parts, but you'd have a
> damn near perfect stochiometric ratio at all times - unlike carbs! What do
> you think?
>
> James
>
> ----- Original Message -----
> From: <bob_wilson@agilent.com>
> To: <datsun-roadsters@autox.team.net>
> Sent: Thursday, March 29, 2001 8:03 PM
> Subject: Jets for Solex
>
> > This might be asking a lot, but I wondered if anyone had a bunch of jets
> for
> > a 40mm Solex carb. To tune it up the manual says basically to try
> different
> > jet sizes while following their procedure. Well, this could cost a lot
> when
> > you don't exactly know how many sizes you need etc. And I need 4 of each
> > jet. If someone would trust me to return them (I would), I would be very
> > careful with them and return all back to you when I knew the right sizes.
> > There are 3 different "jets":
> >
> > Main Jet 120
> > Main Air Jet 180
> > Pilot Jet 50
> > The number shown is the size in my carbs now.
> >
> > Since my engine is "spitting back" out thru the carb throats at idle, the
> > mikuni/solex manual says that I am probably too lean. So need to go to
> > larger Pilot Jet. This is the first Jet I need to get right. Then go on to
> > the others.
> >
> > I have made a stroker out of my 1600 block and head. So it is now a 2.0L,
> > with about 9.2 CR.
> >
> > If anyone could loan me some jets near to the above sizes, or recommend
> the
> > correct sizes for my application, it would be nice.
> >
> > Bob Wilson
> > San Jose, Calif area
> > 1970 1600 stroker 28383
--
<><><><><><><><><><><>
Thomas in Sweden
Nissan Silvia 1965 x2
http://csp311.cjb.net
http://silvia.nu.st
|