Hello All,
I have started to think about installing an alarm in my car that
I have had gathering dust. Does anybody have any general tips/tricks when
doing this. There are a LOT of wires to install. It has a microwave region
sensor and a seperate shock/glass breakage sensor. Any ideas where best
to install these things?? It also has an ignition cut out that cuts the juice
going to the starter/solinoid (not sure which have to re-read instructions) I
have started to install pin switches in the trunk, doors, hood. I am not even
sure where to mount the 'brains' of the unit.
This is NOT meant to start a alarms are not good thread... I got it
gathering dust and I want to use it. Maybe it will stop people from stealing
my
8-ball shift knobs.
Daniel 69 2000
SF CA
|