Pam & Paul Bauman wrote:
> well, two, actually, but I'll gratefully accept input on either or both :)
>
> The first ivolves the heater blower motor. After digging thru what's left of
> my parts, I discovered another wiring harness. This one goes from the blower
> motor to the heater switch. Easy enough. However, there is attached a large
> coil with a bracket on it that I just know screws onto something, but I
> cannot find a set of holes that match anywhere in the firewall or dash.
> where does this pesky bugger go?
>
> The second involves the horn. I can either get the horn to be always on or
> always off. I'm in the computer biz, but gee, this kind of binary action I
> usually reserve to mahines with computers in them! I followed the sequence
> of parts installation from the parts amnual (I thought) but no matter what,
> it is either no horn or all horn, all the time.
>
> Thanks
>
> Paul Bauman
> Westminster, CA
> 67 1600
> http://albums.photopoint.com/j/AlbumIndex?u=881168&a=6499541
Paul,
That wire with the coil goes inside the heater box with the core. The wire
comes out one of those holes through a grommet. I think that the wire goes
between the 2 heater core pipes. I can't remember which side that coil screws
onto inside the heater box. Once you look at it, you shouldn't have too much
trouble. I could look at my heater box this evening if you need more info.
Bob
|