Perhaps you could put some droop snubbers (wire cable or straps) around the
A arms. The dampers should perform this function on standard travel/sprung
set ups, but with your reduced spring length, I guess they come up a bit
short (long?)
Correctly sized dampers would do the job, but where you could find them is
beyond me.
Regards
Calvin Grandy
Second, what keeps them in place when the A-arms are in full
> droop mode? Mine flop around (a lot!!!) when the a-arms droop to the
rubber
> stop on the upper a-arm. That happens even with the rubber gasket and a
1/4"
> aluminum ring spacer installed. Comments or enlightenment? BTW - sway bar
> and streeing linkage not installed yet. Trial fit of sway bar looks like
> it's not going to make any difference anyway.
>
> Tom (scratching his head) P
> SEROC
>
|