It's amazingly simple, and another alternative - the UniSyn - is a very handy
method, too.
UniSyn does reduce flow a bit, but then there is no worry about drilling holes
in the
phenolic spacers and then sealing them afterwards.
Gary McCormick
San José, CA
Robin Krause wrote:
> Some friends at work are helping me tune my carbs and they want to hook up a
> mercury analyzer to synchronize them. They can't figure out where they
> would be hooked up, so they want to drill a hole in each of the brown spacer
> thingies between the carbs and the manifold, then put nipples in there.
> Does anyone have any comments on whether this would work or if there is a
> better way?
>
> Is the listening through a hose technique less black magic than it sounds?
> ________________________________________________________________________
|