All,
There are several sites that sell linkage components. It should be pretty
simple to build it.
Sid
>From: Mike Poorboy <bitterrootprop@nidlink.com>
>Reply-To: Mike Poorboy <bitterrootprop@nidlink.com>
>To: Duram Plummer <Duram@duram.com>,
>"datsun-roadsters@autox.team.net" <datsun-roadsters@autox.team.net>
>Subject: Re: R16 Carburation
>Date: Tue, 11 Jul 2000 09:22:26 -0700
>
>Duram,
>Go ahead an buy the kit and let us know how it works :-)
>You can be our R & D guy.
>
>I did call Pierce Manifolds yesterday and they had one in stock for the
>R16,
>but
>would have to make up the linkage for it.
>
>Mike
>Hayden Lake, ID
>2 69' 2000's and maybe a 1600 ?
>Nowroc with are own Domain name Thanks Daniel, Eric and Susan.
>http://www.nowroc.com/
>http://www.imbris.net/~bitterrootprop/
>http://albums.photopoint.com/j/AlbumList?u=964436
>
>
>Duram Plummer wrote:
>
> > I have been thinking about getting a set of weber dcoe manifold for my
>1500
> > with that same question in mind "will it be to much carburation?" check
>out
> > this link http://www.piercemanifolds.com/yourwebers.htm the last car is
>a
> > 1600 with 40's the kit runs $820 from Piercemanifolds.com and it
>includes
> > the carbs maniold and all the linkage. They told me the kit was jetted
>and
> > setup just for the R16 engine.
> >
> > Duram
> >
> > -----Original Message-----
> > From: Laury, Victor [mailto:LauryV@MTA.NET]
> > Sent: Monday, July 10, 2000 12:27 PM
> > To: 'Mike Poorboy'; datsun-roadsters@autox.team.net
> > Subject: RE: R16 Carburation
> >
> > Just out of curiosity, not having a R16 myself, would dual Weber or
>Mikuni
> > 40's on a R16 be too much carburation without larger valves and serious
>cam
> > lift? on a stroked R-20 I could see it (and have seen it, Stan's car for
> > example).
> >
> > Victor
> > 70 SRL 31113136
> > Los Angeles
> > http://albums.photopoint.com/j/AlbumList?u=123073
> > SoCalROC http://www.ameri-eagle.com/datsun/
> >
> > -----Original Message-----
> > From: Mike Poorboy [mailto:bitterrootprop@nidlink.com]
> > Sent: Monday, July 10, 2000 11:02 AM
> > To: datsun-roadsters@autox.team.net
> > Subject: R16 Carburation
> >
> > List,
> > I just found out that the Mikuni, Weber side draft manifold is still
> > available. Dual 44's 0r 45 DCOE's on a stroked 1600. Plus you can even
> > use the smaller 40's on them.
> >
> > Mike
> > Nowroc
>
________________________________________________________________________
|