Daniel,
The thermostat sits in a slot in the housing. Because it sits sideways it has
the
potential to move out of position during the time that you insert the
thermostat and
secure the bolts. Because everything is not flush you can get a lea and when
you
over tighten the bolts you can crack the housing. You can use a little gasket
sealer
on the thermostat to prevent it moving out of position.
Dana
Dan Neuman wrote:
> Hello All,
> Got the new rad in got both new temp senders in.. put it all back
> toghether and filled the rad... Bit of water leaking out around the elbow..
> tighten down nuts a bit more and CRACK!!!!!!!!!!!! I managed to once again
> crack the $&@%$!@#@^!%#^%&^!%$^@!!*!*&@^$*%!!*#@^%!!@* !*#V !@*&#!
> elbow... SInce I have already done this I thought I was being carefull.. What
>did
> I do wrong??
>
|