Okay, experience when hooking up a magnet to drive
shaft for cruise control (old time method)
Take a hose clamp and put in it on the u-joint right
behind the transmission. This eliminates alot of the
movement up-down and side-to-side. Score the surface
of the hose clamp with sand paper and the bottom of
the magnet the same way. Epoxy the magnet to the hose
clamp. I used JB Weld. Then make a bracket to hold the
sendor at the desired location. I mounted mine to the
tranny via an extra hole I found that was threaded.
This worked for 9 years on my 1980 ford 4x4 that went
every where on and off road.
Worth a try.
Don Miller
68 1600 (for sale 3000 obo)
69 Turbo V-6 Race Car
70 2000
Meridian, ID
__________________________________________________
Yahoo! Photos -- now, 100 FREE prints!
http://photos.yahoo.com
|