Oops I was thinking VG30DTT not VG30TT.
Mike
Mike Poorboy wrote:
> Ron,
> Joe Klokkevold said the same thing yesterday before Mike even
> replied with his 350 horsepower U20. Joe has alot of experience
> with Datsun/Nissan engines. He said about the same thing you did.
> although he even stated that the FJ20 is not a match for the SR20.
> He felt that the cam timing chain was a weak link along with the
> cast iron block casting. He felt that the U20 was good for around
> 250 horsepower. Normally aspirated ones around 210 with 13 to 1
> pistons.
>
> I tend to believe what he says. The U20 designers never intended
> it to be a turbocharged power plant.
>
> This is my opinion based on information I have received from various
> other Datsun / Nissan owners.
>
> I am not saying Mike's car doesn't produce a fair amount of power,
> but I don't think it is 350. Didn't the VG30ETT only produce 320
> horsepower.
>
> Maybe now I will seriously consider an SR20 :-}
>
> Mike
> Ron Hamilton wrote:
>
> > Mike;
> >
> > Is this the U-20 turbo of yours that had the cobbled up single SU carb with
>a
> > welded together float bowl because it kept running out of gas? I have
>trouble
> > comparing the single overhead can two valve per cylinder, mile long cam
>chain,
> > old distributor technology that gets 350? horsepower with the FJ-20 that
>starts
> > out with 4 valves per,computerized ignition, fuel injected, dual overhead
>cams,
> > designed for charging to 25 lbs,175 horse stock motor that with custom equal
> > length exhaust header and new Mitsubishi 16G turbo with 9.5 lbs boost and
>the
> > numbers only come to approximately 305 horsepower. My math must be wrong!
>Must
> > be the fact that the FJ tachs to 8500 rpm +or is it the 3 inch throttle body
> > that isn't as good as the old welded up carb?
> > :-)
> >
> > Ron
> >
> > Mike Kerr wrote:
> >
> > > <I'm curious as to how many of you are relying on speedometer readings and
> > > how many are actually calculating speed? Also, are you using a U20 or
> > > something else, and how did the car feel at top speed, handling
> > > wise...fairly secure or downright scary? Mine felt rather twitchy, >
> > >
> > > U20 motor but the turbo does and some extra HP over twice as much
> > > at 150 mph on the gauge (stock rear end 3:70 with stock dia tires)
> > > was pushing 7 lbs. boost to keep it at 150, the waste gate was set for 15
> > > lbs. but the turbo would push it to 17 to 18 lbs.., needed larger waste
> > > gate. the u20 breaths so well it gains hp with boost quite well.
> > > At 120 you could change lanes on a dime, at 150 i wasn't trying to do
> > > anything but go strait on the road. but it was not twitchy at all. I have
> > > the front dropped 2 inches and 66 rear springs this keeps the air on top
>of
> > > the hood pushing the front end down. I have driven some roadsters I
> > > wouldn't have wanted to go 80 mph in also.
> > >
> > > Mike Kerr
> > > Roadster Restoration
> > > 3730 Todrob LN.
> > > Placerville CA. 95667
> > > Ph.# 530-644-6777
> > > Fax# 530-644-7252
> > > E-mail: mikekerr@innercite.com
> > > Web page : http://www.innercite.com/~wolfgang
> > > Visa & master card
> > > -----Original Message-----
> > > From: Rob Robinson <FastrTime@t-three.com>
> > > To: datsun-roadsters@autox.team.net <datsun-roadsters@autox.team.net>
> > > Date: Tuesday, December 14, 1999 6:24 AM
> > > Subject: High velocity
> > >
> > > >I went for a speed run last Saturday just to see what my 2000 would
>do...I
> > > >hadn't tried a top speed run since prepping the car for CSP several years
> > > >ago and with all this talk of speed records...I just couldn't stand it!
> > > >Anyhow, I ran out of steam at 6350rpm in 5th, 3.89's, and 205/50/15.
>Works
> > > >out to about 133mph although the speedo (Autometer) said 142. The car
> > > >probably would have gone faster with 3.70's or larger diameter tires, as
> > > >6350rpm is a bit past peak hp. BTW, the 6350rpm figure is not a guess, it
> > > >was plucked from my fuel computer.
> > > >
> > > >I'm curious as to how many of you are relying on speedometer readings and
> > > >how many are actually calculating speed? Also, are you using a U20 or
> > > >something else, and how did the car feel at top speed, handling
> > > >wise...fairly secure or downright scary? Mine felt rather twitchy, but
> > > >that's expected of a car set up for under 60mph autocrossing. I don't
>think
> > > >I would have even attempted such a speed run with stock suspension/tires.
> > > >
> > > >Non-Roadster content: Anyone got an impressive personal top speed in a
> > > >non-roadster? I used to own a '70 240Z with a 13B rotary
> > > turbo...intercooler
> > > >filled the entire nose, header wrapped to the front of the engine where
> > > >there was room for the turbo, 3.54 viscous LSD (from a Q45) and
>225/50/16.
> > > I
> > > >hit the rev limiter in 4th (8500rpm) and got scared. That calculated to
> > > >about 185mph, and it could have gone faster...with someone else driving
>it.
> > > >
> > > >
> > > >Rob Robinson
> > > >CSP 67 2000 (not Solexes...45mm throttle bodies)
> > > >Roanoke, VA
> > > >
> > > >
|