Van,
You nailed it.
The ground was to metal but there was some adhesive on the surface. Used a
dremel tool to remove it and the noise was completely eliminated.
Thanks,
Ray
At 10:25 PM 07/18/1999 EDT, DemonTSi@aol.com wrote:
>In a message dated 7/18/99 6:53:44 PM Pacific Daylight Time,
>raycole@mindspring.com writes:
>
><< Just had a new Kenwood radio/tape unit intalled in my 68 2000.
>
> On AM (only AM and only with the engine running) I am getting noise that
> increased with engine speed so it must be ignition related. >>
>
>Did you check the ground to the radio? A poor ground can lead to a noise
that
>is rpm-dependent like yours. Just make sure it's connected to a large
>grounded piece of BARE metal with a clean connector....If that doesn't help,
>there might be a problem with the deck.
>
>Van
>
|