Sorry I don't have this information, but I am curious what you are up to?
Are you perhaps making your own bellhousing (clutch housing)?
Regards,
Jim B.
----- Original Message -----
From: "jon" <jonaxt@pacifier.com>
To: <buick-rover-v8@autox.team.net>
Sent: Monday, March 04, 2002 10:23 AM
Subject: clutch housing bolt pattern
> Does anyone have precise dimensions for the mounting holes of the clutch
> housing? In particular I need the position of the two dowels relative to
the
> crank. As close as I can measure they are both on 7.281 (7 9/32?) radius.
> The one above the starter is 22.06 degrees above the horizontal, and the
> other dowel is on a horizontal line with the crank. Jon
///
/// buick-rover-v8@autox.team.net mailing list
///
|