Mike Burdick writes:
> I have used a "hard" drift to do this. If you are going to replace the
> bearing anyway (you might as well since it's out) it won't matter if you
> mar it. Be careful not to drift into the case though. Say Al, do you think
> that's why they call it a "drift"?
Actually, large sockets make great drifts. I used a 36mm socket to
drive the flange onto my rear differential shaft. Worked like a
charm. As for why they are call drifts... Its because if your mind
drifts, so will the drift... Which can be a real bummer...
---
-Scott
I let my past go too fast,
No time to pause -- If I could slow it all down. -Rush
|