dixon,
I tried the same techniques as you have on an old mini engine I purchased
they did not work on that engine either.
one thing you might try is heating around the perimeter of the piston
with a propane torch, then spray in wd40 and pound with sledgehammer on
block of wood. if this does not work, you can do what I did...bring
engine to the machine shop and let them use the hydraulic press. that will
do it.
jim fuerstenberg
186,000 miles per second, it's not just a good idea
it's the law!
jfuerstenberg@dcmdc.dla.mil or
xgg2356@dcmdc.dla.mil
The opinions stated herein are solely my own and not those of my employer.
|