Carl asks:
> I've seen frequent mention of the term "flats" when referring to adjusting
>carbs. How far is a flat? Is it 1/2 turn of the screw, corresponding to the
>flat side of a screwdriver? Or what?
The nut that is adjusted is usually hexagonal. A "flat" is one
side of the hexagonal nut (ie. 1/6 turn).
Bill
------------------------------------------------------------------------
Bill Sohl (K2UNK) || email
Bellcore, Morristown, NJ || UUCP bcr!taichi!whs70
(Bell Communications Research) || or
201-829-2879 Weekdays || Internet whs70@taichi.cc.bellcore.com
------------------------------------------------------------------------
|