In my shop manual, I can't find a torque value for the Alpine's axle
nuts (the nuts that hold the hub onto the axle). When my dad and I
put the hubs from the parts car on, we basically tightened them as
tight as we could get them. This turned out to be about 120 ft-lbs,
using a low-budget Sears torque wrench. Should these nuts be torqued
to a specific value, or just as tight as we can get them?
TIA,
---------------------------------------------------------------------
T.J. Higgins 205-730-7922 | higgins@ingr.com (Internet)
Mapping Sciences Division | uunet!ingr!higgins (uucp)
Intergraph Corp. M/S IW17A6 Huntsville, Alabama, U.S.A. 35894-0001
|