-> Question: My clutch _barely_ disengages. The pushrod is attached to
->the middle hole in the fork lever. I tired the outer hole (to reduce pedal
->effect) but it wouldn't disengage fully there. I haven't tried the topmost
->hole yet. Note that the previous owner installed a new clutch soon before
->I bought it (supposedly) and appears to have put in a new clutch master cyl.
->For the time being, i'm getting good at rev-matched downshifts. :-) Any
->ideas? Should I bleed it, try the upper hole, something else?
->
Answer: I just replaced my clutch last week. The pushrod is on the
topmost hole on the lever. It was on the topmost hole before I replaced
the clutch. And the old clutch was down to one of the rivets....
iii
|