> Somebody just mentioned snaps for tops on TRs and that reminded me
> of a problem I'm having with my TR6. Is there anything that can be
> done about male(?ones screwed into the body) snaps that are loose
> because of the screw hole being distorted to the point they no
> longer allow the snap screw to tighten? I don't think oversize snap
> screws are available, but ya never know. Any snap wizards out there?
If you can get to the back side, you could fashion a small piece of sheet
metal for the screw to bit into (or an appropriate sized washer if you
are using pop rivets).
I have also found that a small amount of silcone sealer/glue will help
keep the snap bases from vibrating loose.
--
Darrell Walker
walker@denim.hp.com (hplabs!denim!walker)
(916) 785-4059
Roseville, CA
|