bricklin
[Top] [All Lists]

Re: [Bricklin] Air door problem

To: <jblair1948@cox.net>, <bricklin@autox.team.net>
Subject: Re: [Bricklin] Air door problem
From: Alan Coleman <colemaal@hotmail.com>
Date: Wed, 21 Dec 2011 22:40:07 +0000
Sounds like a bad solenoid.  I had the same thing happen on a sprinkler system
and it drove me crazy trying to figure it out.  Low pressure/no pressure, the
solenoid operated valve worked fine but crank the pressure up and it would not
open. I checked with the manufacturer and they told me that sometimes when
they go bad they will work fine with no pressure or a small amount of pressure
on them, but they won't have enough strength to work when full pressure is on
them.


AlanC
#246


> Date: Mon, 19 Dec 2011 08:18:52 -0500
> To: bricklin@autox.team.net
> From: jblair1948@cox.net
> Subject: Re: [Bricklin] Air door problem
>
> At 05:25 PM 12/18/2011, Scott Isensee wrote:
>
> >I am stumped by an air door problem. The drivers side works fine, but on
the
> >passenger side, the up air solenoid won't trigger most of the
> time. If I bleed
> >to the air pressure down to 40 pounds so the passenger side solenoid works
> >every time, but when I run the pressure up to about 100 it fails to
trigger
> >most of the time.
>
> Scott,
>
> So if I understand you, you have:
>
> 1. checked the voltage going to the solenoids and that's OK.
> 2. probem occurs using both inside and outside switches.
>
> 3. You say you have air latches, but you didn't say if the passenger
> side latch is
> firing. I'm assuming it is, but I'll ask any way. Is it?
>
> 4. You've run power directly to the solenoid - and it didn't fire.
>
> 5. you cleaned and replaced the solenoid.
>
> 6. you said the air lines for the passenger side is not clogged.
>
> None of this helped. The only thing left I can think of is that the
> ground wire for
> the pass. up solenoid is getting a good ground. Check and see if each
ground
> wire for the solenoids goes to it's own mount to the mounting plate or are
they
> all tied to one point?
>
> Also check to see that the wire is a good connection to the eyelit
> (if the wire has
> one). Then how are all these ground wires actually connected to the chassis
> grouns? Check those connections. Make sure the metal is clean an bright,
the
> screws are tight? You might also want to put some dielectric past on
> each of the
> ground wires where they connect to the panel.
>
> Have you tried to call Terry and talk to him or John?
>
> Keep us posted.
>
> John
>
> John T. Blair WA4OHZ email: jblair1948@cox.net
> Va. Beach, Va
> Phone: (757) 495-8229
>
> 48 TR1800 48 #4 Midget 65 Morgan 4/4 Series V (B1106)
> 75 Bricklin SV1 (#0887) 77 Spitfire 71 Saab Sonett III
> 65 Rambler Classic
>
> Morgan: www.team.net/www/morgan
> Bricklin: www.bricklin.org
>
> If you can read this - Thank a teacher!
> If you are reading it in English - Thank a Vet!!
>
> From Dennis Prager - The American Trilogy:
> e pluribus Unum, "from many, one."
> In God We Trust
> Liberty - the power of choosing, thinking, and acting for
> oneself; freedom from control or restriction
> _______________________________________________
> Bricklin@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/bricklin/colemaal@hotmail.com
_______________________________________________
Bricklin@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>