Are you sure they are not bottoming out in the hole, if they are aftermarket
studs that is a common problem,the aftermarket ones almost fit, The right way
to fix it is to cut a bit off the end of the stud so they don't bottom out. If
they are not threaded high enough, they are just plain no good,probably
Chinese made almost right, return them and buy better quality ones. but they
are more than likely 1/8" too long on the head end and just need to be cut or
ground down.
On 5/19/2009 10:30:34 PM, Greg Schroeder (gschroeder@comcast.net) wrote:
> OK, getting ready to install my rocker stud through the push rod guide
> plates
> into the head and there is a gap since it is not threaded all the way.
> What
> would be the recommended way to allow them to tighten up. Flat washer
> above
> or below the guide plate or is there another method? I am leaning
> towards
> below the guide plate since the stud has a flare that will prevent
> the guide
> plate from slipping.
>
> Greg 0036
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Bricklin@autox.team.net
> http://autox.team.net/mailman/listinfo/bricklin
>
> You are subscribed as rick@hightechcoatings.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Bricklin@autox.team.net
http://autox.team.net/mailman/listinfo/bricklin
http://www.team.net/archive
|