OK, getting ready to install my rocker stud through the push rod guide plates
into the head and there is a gap since it is not threaded all the way. What
would be the recommended way to allow them to tighten up. Flat washer above
or below the guide plate or is there another method? I am leaning towards
below the guide plate since the stud has a flare that will prevent the guide
plate from slipping.
Greg 0036
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Bricklin@autox.team.net
http://autox.team.net/mailman/listinfo/bricklin
http://www.team.net/archive
|