Had to create the center duct work since the vent that I purchased was to
large. I constructed them out of clear acrylic and aluminum tape. I put clear
sealant/glue on the seams, then covered them with foam insulation. I was able
to cut the acrylic for the angle required. Great air flow now.
One thing I noticed is that when I left the compressor switch in the on
position it was still turning on the magnetic clutch. I did not realize this
until I was tightening the AC belt and touch the clutch and it was warm. Is
this not cutting off with the ignition normal?
Greg 0036
|