You can always contact Bob or Terry, I'm sure both of them
have it.
Seth
#1544
*********** REPLY SEPARATOR ***********
On 11/30/2004 at 10:18 PM Paul J. Amoroso wrote:
>I have had to replace some of my body molding. I went to a local shop
>that supplies paint & molding to body shops. They had some very close
>but not an exact match......it was about 1/8 inch narrower. I replaced
>one side of the car and left the other side alone. It comes in a roll
>and you cut it to fit. Make the cuts (through the thickness) at an
>angle to match those on the car.
>
>QUESTION: how does everyone that has had body molding come loose,
>reattach them? I used a very sticky two sided tape but it seems to only
>last for a couple years. Due to the joints in the body panels, you
>don't get a very good surface to stick to. Anybody have a suggestion?
>Thanks.
>
>Amo (Paul Amoroso)
>#1207
>
>
>
>Early, Stephen wrote:
>
>>Does anyone know where I can get one piece of original body side molding
>for
>>my '74? It's the piece behind the tire on the right front fender.
>>
>>Stephen I. Early
>>Portfolio Conversions
>>Technology Sector-MBNA America
>>302.457.4788
>>800.441.7048 x74788
>>stephen.early@mbna.com
|