I have had to replace some of my body molding. I went to a local shop
that supplies paint & molding to body shops. They had some very close
but not an exact match......it was about 1/8 inch narrower. I replaced
one side of the car and left the other side alone. It comes in a roll
and you cut it to fit. Make the cuts (through the thickness) at an
angle to match those on the car.
QUESTION: how does everyone that has had body molding come loose,
reattach them? I used a very sticky two sided tape but it seems to only
last for a couple years. Due to the joints in the body panels, you
don't get a very good surface to stick to. Anybody have a suggestion?
Thanks.
Amo (Paul Amoroso)
#1207
Early, Stephen wrote:
>Does anyone know where I can get one piece of original body side molding for
>my '74? It's the piece behind the tire on the right front fender.
>
>Stephen I. Early
>Portfolio Conversions
>Technology Sector-MBNA America
>302.457.4788
>800.441.7048 x74788
>stephen.early@mbna.com
|