I can honestly say that no this will not work. You are dealing with a sheet
of acrylic plastic with a fiberglass backing. I have personally heard of many
different things being tried to flatten these out and all have the same
success quotient ( 0% ) the problem is the fact that the acrylic is a memory
plastic that remembers what it was like before it was made into a body part,
and is
trying very hard to go back to that.. So hard in fact that it will flatten
the top edge of a hatch that not only has the fiberglass backing but a steel
support inside it as well.. Your best solution would be to get a set of
replacement headlight covers that we at the shop just happen to make that will
not do
the warping since they do not have the acrylic.. they are full fiberglass
reproductions.
John Lodge
|