So, I'm finally going to break down and buy the proper friggen tools to do
the job instead of using WD-40, duct tape, vise-grips, a BFH and a sparkle
wrench yet again. ;^)
Does anyone have contact info for Miller Tools, maker of specialty
automotive tools? An online resource would be preferred. I'm specifically
looking to buy a wheel stud extractor to fit my Dodge Neon's disc brakes
instead of using a BFH and potentially hurting the hubs or bearings.
Oh, and to install the new studs what do all y'all do? Use an open-ended
nut and a stack of washers and just "wrench" it on?
As usual, Thanks in advance.
Eric Linnhoff in KC
1998 Dodge Neon R/T (see-dan)
STS #69 TLS #13
knuckledragger@kcweb.net
http://www.geocities.com/eric10mm/KnuckleDragger
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Partial archives at http://www.team.net/archive
|