Bill,
I have a spare lying around in my shop somewhere, so I'll measure it this PM,
and let you have the dims.
If it's leaking, it's likely to be the rubber washer/seal.
By the way, another potential cause for the gague not working is the balance
pipe between the LH and RH tank being pinched/blocked. This prevents the LH
tank from filling, and reads empty, even when the RH tank is full.
Julian.
-----Original Message-----
From: Bill Mounce <bmounce@rcn.com>
To: alpines@autox.team.net
CC: 'RICHARD FRITZ' <wizzzbang@verizon.net>
Sent: Tue, 4 Aug 2009 12:24
Subject: [Alpines] fuel sender measurement
Hello all
My fuel sender is not working, and worse, it is leaking. I am going to pull
it out and bench test it (i.e. stare at it with a slack jaw and puzzled
look, most likely). Prior to yanking it, I wish to fabricate a metal disk
to replace it for the time being. Would someone have either a left hand
tank, or a sending unit, which they could measure and provide me with the
correct diameter? That way I don't have to leave it open (we have an open
container law in my township!).
Thanks in advance,
Bill Mounce
Easton, PA
1967 SV
Alpines@autox.team.net
http://autox.team.net/mailman/listinfo/alpines
http://www.team.net/archive
________________________________________________________________________
AOL Email goes Mobile! You can now read your AOL Emails whilst on the move.
Sign up for a free AOL Email account with unlimited storage today.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Alpines@autox.team.net
http://autox.team.net/mailman/listinfo/alpines
http://www.team.net/archive
|