Re: O/D Driveshaft Length and Iso. Sw.

[jumpinjan <jservaites@woh.rr.com>]

Ron Tebo wrote:
> 
> Russ, Chris, and All:
> 
> I am planning to install a SV o/d transmission into a non o/d series I
> with SV all synchro trans. The measurement I obtained for the
> drive-shaft from my archive, is that it should be shortened by 3 5/8ths"
> to 30 5/8"

Ron, I just measured 2 OD shafts and I measure 29.5" from center of yoke
to the opposite yoke center. As a reference check, a non-OD measures
32.25"
Jan Servaites