Russ, Chris, and All:
I am planning to install a SV o/d transmission into a non o/d series I
with SV all synchro trans. The measurement I obtained for the
drive-shaft from my archive, is that it should be shortened by 3 5/8ths"
to 30 5/8"
yoke to yoke. (Russ Eshelman) (Chris Stephenson apparently did this
last summer). I would just like to have confirmation before I cut!
Also, does any one know where I can obtain an 3-4 isolator switch (since
I am installing on a transmission that did not previously have an overdrive)?
Thanks in advance for any help you can give.
Ron Tebo
|