But is this "step" a problem? It may look unpleasant but it can give some
turbulence in the incoming petrol fumes that will give better atomisation and
better fuel economy.
Kristian J
----- Ursprungligt meddelande -----
Fren: "Tom Hill" <tom.hill@att.net>
Till: "alpine autox" <alpines@autox.team.net>
Skickat: den 14 maj 2003 17:39
Dmne: RE: Holbay question
> The Series 4 and 5 manifolds will bolt to the Holbay head, but the intake
> port is smaller on the Holbay head. So, if you don't use the Holbay
> manifold, you end up with a "step" where the manifold meets the head. You
> could grind the head to match the manifold, but IMHO, this would ruin the
> Holbay head. A better option would be to have the S IV/V manifold welded up
> and match it to the head.
>
> My 0.02USD worth,
>
> Tom Hill
>
> -----Original Message-----
> From: owner-alpines@autox.team.net
> [mailto:owner-alpines@autox.team.net]On Behalf Of KKJ
> Sent: Friday, May 09, 2003 9:51 AM
> To: alpine autox
> Subject: SV: Holbay question
>
>
> Inlet or exhaust?.........but the answer is yes
>
> Kristian J
>
>
> ----- Ursprungligt meddelande -----
> Fren: <SunbeamAlpine64@aol.com>
> Till: <alpines@autox.team.net>
> Skickat: den 9 maj 2003 12:55
> Dmne: Holbay question
>
>
> > Hi guys
> >
> > I'm sure I've seen the answer to this quesiton somewhere but can't find
> it..
> >
> > Can standard Series 4 or 5 manifolds be used on a Holbay H120 head ?
> >
> > thanks
> > Mark
|